08-14-2018, 12:04 PM
Good Morning,
First of all, thank you so much for putting this information out there.I am super new to Gekko, and have some JavaScript experience, but am having trouble getting everything set up and backtested. I'm hoping you can help me out!So far, I have installed nodeJS, Gekko, and the tulip/talib indicators. I have also copied and pasted your code from the nodeJS part of the module into a my own config file, and it does run when I do a "node gekko.js --config .\dynamiqueStopLossCommandLine.js--backtest", but it seems as though it is only using the MACD indicator. When I looked at the config file, I see in the advisor section that it is just referencing MACD. I tried to change this to the filename of the strategy I copied into the strategy folder of Gekko, but then I get an error that states Cannot read property 'RSI' of undefined.
Any help you could provide would be greatly appreciated!!!!!
I am very excited yet humbled by my entry into the trading world.
Sincerely,
Kyle
First of all, thank you so much for putting this information out there.I am super new to Gekko, and have some JavaScript experience, but am having trouble getting everything set up and backtested. I'm hoping you can help me out!So far, I have installed nodeJS, Gekko, and the tulip/talib indicators. I have also copied and pasted your code from the nodeJS part of the module into a my own config file, and it does run when I do a "node gekko.js --config .\dynamiqueStopLossCommandLine.js--backtest", but it seems as though it is only using the MACD indicator. When I looked at the config file, I see in the advisor section that it is just referencing MACD. I tried to change this to the filename of the strategy I copied into the strategy folder of Gekko, but then I get an error that states Cannot read property 'RSI' of undefined.
Any help you could provide would be greatly appreciated!!!!!
I am very excited yet humbled by my entry into the trading world.
Sincerely,
Kyle