|
How to run Rsi-Bull-bear with command line (cli)
|
With config which You send all is fine. Save it file to Gekko's main folder and then:
Code: node gekko -c rsi-bullbear-adx-xfff-config.txtLeave JSON file alone  This file is not needed. Only run above command.
My projects [Strategies] [Datasets]
|
| Messages In This Thread |
|
How to run Rsi-Bull-bear with command line (cli) - by ankasem - 04-04-2018, 04:55 PM
RE: How to run Rsi-Bull-bear with command line (cli) - by xFFFFF - 04-05-2018, 07:37 PM
RE: How to run Rsi-Bull-bear with command line (cli) - by ankasem - 04-05-2018, 08:22 PM
RE: How to run Rsi-Bull-bear with command line (cli) - by xFFFFF - 04-05-2018, 08:32 PM
RE: How to run Rsi-Bull-bear with command line (cli) - by ankasem - 04-05-2018, 10:11 PM
RE: How to run Rsi-Bull-bear with command line (cli) - by xFFFFF - 04-06-2018, 05:08 AM
RE: How to run Rsi-Bull-bear with command line (cli) - by ankasem - 04-06-2018, 05:38 AM
RE: How to run Rsi-Bull-bear with command line (cli) - by Araceli - 05-31-2019, 06:32 AM
|
