+- Gekko Forum (https://forum.gekko.wizb.it)
+-- Forum: Gekko (https://forum.gekko.wizb.it/forum-13.html)
+--- Forum: General Discussion (https://forum.gekko.wizb.it/forum-14.html)
+--- Thread: How do you monitor Gekkos runnng via the CLI (/thread-57225.html)
How do you monitor Gekkos runnng via the CLI - coiner2018 - 05-30-2018
Hi guys, apologies if this has been asked/answered before. I did search but couldn't find an answer...
When paper-trading or live-trading via the CLI, how do you guys actually monitor/understand what Gekko is doing?
I've got Gekko configured to send me Pushover notifications of long/short trades but when I check the command line output, there doesn't seem to be any entries explaining any trades. All I see is thousands of debug messages, and then a "PROFIT REPORT" at the point that it sent me the Pushover trade notification.
Is there not somewhere where these trades are logged and are accessible? Am I missing something?
This is an example of all I see (Debug messages with the occasional PROFIT REPORT lines):
Code:
2018-05-29 22:53:08 (DEBUG): No new trades.
2018-05-29 22:53:27 (DEBUG): Requested BTC/GBP trade data from GDAX ...
2018-05-29 22:53:28 (DEBUG): Processing 1 new trades. From 2018-05-29 22:52:56 UTC to 2018-05-29 22:52:56 UTC. (a few seconds)
2018-05-29 22:53:47 (DEBUG): Requested BTC/GBP trade data from GDAX ...
2018-05-29 22:53:48 (DEBUG): Processing 1 new trades. From 2018-05-29 22:53:17 UTC to 2018-05-29 22:53:17 UTC. (a few seconds)
2018-05-29 22:53:48 (INFO): (PROFIT REPORT) original simulated balance: 270.00000000 GBP
2018-05-29 22:53:48 (INFO): (PROFIT REPORT) current simulated balance: 269.75600980 GBP
2018-05-29 22:53:48 (INFO): (PROFIT REPORT) simulated profit: -0.24399020 GBP (-0.09036674%)
{"status":1,"request":"d3c53f4f-81da-4c9d-918e-a4ea7903ec26"}
2018-05-29 22:54:07 (DEBUG): Requested BTC/GBP trade data from GDAX ...
2018-05-29 22:54:08 (DEBUG): No new trades.
2018-05-29 22:54:27 (DEBUG): Requested BTC/GBP trade data from GDAX ...RE: How do you monitor Gekkos runnng via the CLI - ankasem - 05-30-2018
hi
I have been looking for your problem for 2 months
+
utc and local zone difference +2
run cli then ui run 2 hours later you will see the result
-----------------------------------------------------------------------------------------------------------
now handle with the link below
https://forum.gekko.wizb.it/thread-56697.html